Assembly
© Copyright 2005, Creative Playthings
LEXINGTON
19686-300 Rev N (01-19)
Page 12
ASSEMBLY INSTRUCTIONS
STEP 6 - Inside Stringers
Locate the three Inside Stringers (G). The Inside Stringers
(G) are installed between the Platform Sides (O). Attach
each Inside Stringer (G) using two 5/16 x 4" Lag Screws and
Flat Washers as shown. Make sure the Outside Stringers
(H) and Inside Stringers (G) are aligned across top edges..
STEP 7 - Safety Rail:
Locate the Safety Rail (A); fasten it to the Corner Posts (F)
on the side a Swing Frame is to be positioned using two 5/16
x 3" Lag Screws with 5/16" Flat Washers as shown.
STEP 8 - Angle Braces:
Fasten an Angle Brace (B) to each end of both Platform
Sides (O) using four 5/16 x 2-1/2" Hex Bolt Assemblies. Do
not tighten these bolts yet. The Angle Braces (B) should be
fastened so that the angled end is flat against the Corner
Post nearest to it.
Fasten an Angle Brace (B) to each end of the Platform Ends
(V) using four 5/16 x 2-1/2" Hex Bolt Assemblies. Do not
tighten these bolts yet. The Angle Braces (B) should be
fastened so that the angled end is flat against the nearest
Corner Post.
G
V
O
O
A
B
O
O
V
B
V
O
