LEXINGTON WITH TENT ROOF
19685-100 Rev S (07-21)
© Copyright 2005, Creative Playthings
Assembly
Page 11
ASSEMBLY INSTRUCTIONS
O
V
H
V
5/16 x 5-1/2"
Hex Bolts
5/16 x 4" Lag
Screws
5/16 x 2-1/2"
Hex Bolts
G
V
O
O
B
B
Platform Side
Omitted for
Clarity
Move the tower to the final intended postion. Use a carpenter's level to assure the base is level and the
posts are plumb.
STEP 6 — Outside Stringers:
Mount the Outside Stringers (H) to the inside of the
front and rear corner posts using two 5/16 x 5-1/2"
hex bolt assemblies as shown. Start the hex bolt
from the outside of the gym. Push each bolt through
the bottom hole in the front or rear platform ends
and the corner posts before passing through the
outside stringer.
Make sure the platform ends and outside stringers
align across the bottom edge.
Hint: The holes in the outside stringers are offset
from the center of the board; you may have to flip
the board to achieve proper alignment.
STEP 7 — Inside Stringers
Mount each of three Inside Stringers (G) between the platform
sides using two 5/16 x 4" Lag Screws and Flat Washers as shown.
Make sure the outside stringers and inside stringers align across
top edges.
STEP 8 — Angle Braces:
Fasten an Angle Brace (B) to each end of both platform sides
using four 5/16 x 2-1/2" hex bolt assemblies. Do not tighten yet.
Fasten each angle brace so the angled end is flat against the
nearest corner post.
Fasten an Angle Brace (B) to each end of the platform ends using
four 5/16 x 2-1/2" hex bolt assemblies. Do not tighten yet. Align
each angle brace so the angled end is flat against the nearest
corner post.
