Assembly
© Copyright 2004, Creative Playthings,
PINE ROCK CLIMBER
19581-700 Rev E (01-18)
Page 4
ASSEMBLY INSTRUCTIONS
STEP 6 — Fasten Climbing Rocks:
Fasten a Climbing Rock to each pair holes in the Rock Boards.
Use 1/4 x 1-1/2" Hex Bolts, 1/4" Lock Washers, 8mm Flat
Washers and 1/4" weld nuts. Do not over-tighten the fasten-
ers. The bolt must seat completely into the Climbing Rock,
and not protrude more than a 1/8" past the end of the weld
nut. Protruding bolts can be a hazard to users, replace any
protruding bolts.
STEP 7 — Drill Upper Wall Support:
Use a tape measure to determine the center of the gym Wall
Support above the middle of the Rock Climber. Mark the posi-
tion and drill a 1" diameter hole through the Wall Support at
the mark. Smooth any rough edges.
STEP 8 — Fasten Rope:
The Climbing Rope Assembly comes pre-knotted on ap-
proximately 12" centers. This is done to prevent the rope from
separating and it provides a better grip. DO NOT MODIFY
THE DESIGN OF THIS ROPE. IF THE ROPE IS REPLACED,
IT IS EXTREMELY IMPORTANT THAT YOU MAINTAIN THE
SAME DESIGN AND CONSTRUCTION.
Insert the 3/4" Knotted Rope (F) though the hole in the gym
Wall Support. Tie a figure eight knot at the end of the rope,
inside the gym. Leave at least 2" of rope beyond the end of
the knot.
Pre-stretch the rope before tieing the bottom end. The bot-
tom end of the Rope MUST pass under the bottom Spacer
Board and through the hole in the bottom of the Center Rail.
Pull the Rope through the hole until it is tight and tie a knot
in the end.
Check the rope periodically to ensure that it has not loosened.
Tighten the rope when necessary.
WARNING: AT NO TIME SHOULD THE BOTTOM END OF
THE ROPE BE UNTIED OR LOOSE ENOUGH TO FORM
A LOOP. THIS PRESENTS EXTREME DANGER TO YOUR
CHILDREN.
Cente
r
1" Diameter
Figure 8
Knot
Overhand
Knot
Set Rails into
ground
Important: Set the rails of the Rock Climber
into the ground so the Rope touches the
ground.
