PINE ROCK CLIMBER
All hardware on this set is specially
coated for corrosion resistance. If non-
Creative Playthings hardware is used, it
MUST be galvanized or stainless steel.
SPECIAL NOTES
TOOLS REQUIRED FOR ASSEMBLY
• The Rock Climber can only be used on Play Sets with a
5'
platform height.
• All the Hand Holds supplied must be fastened to your Rock
Wall. There should be no unused mounting holes left on
the Rock Wall. These unused holes could present a finger
entrapment hazard to your child.
• Keep the Hand Holds clean so that they can be inspected for
cracks and sharp edges. Replace damaged Hand Holds.
• Replace bolts or weld nuts that are stripped or cross
threaded.
• Review your original Playset Assembly Manual and your
Owners Manual before assembly of your Rock Climber.
• Provide a soft surface free from obstructions 6' out from
the base of the Rock Climber. See your original Playset
Instructions for recommended play surfaces.
• 7/16" & 1/2" Socket Wrench
• Drill with 1/8", 3/8", & 1" Diameter Bits
• Screwdriver or Drill with T25 Screw Tip (Torx)
• Tape Measure
A 2 ea. 33598-102
Angled Rail 2 x 4 x 68-3/4"
B 1 ea. 33599-102
Center Rail 2 x 4 x 68-3/4"
C 5 ea. 32220-102
Rock Board 5/4 x 6 x 46"
D 6 ea. 32219-102
Spacer Board 5/4 x 6 x 46"
E 1 ea. 33568-102
Top Rock Board 5/4 x 6 x 46"
F 1 ea. 40400-100
Knotted Rope
4 ea. 17001-105
Weld Nut 5/16"
26 ea. 17001-104
Weld Nut 1/4"
4 ea. 12017-206
Lock Washer 5/16"
26 ea. 12017-205
Lock Washer 1/4"
4 ea. 12002-206
Flat Washer 5/16"
26 ea. 17002-204
Flat Washer 8 MM
4 ea. 17003-611
Hex Bolt 5/16-18 x 1-1/2"
24 ea. 17003-609
Hex Bolt 1/4-20 x 1-1/2"
2 ea. 17003-1609 Hex Bolt 1/4-20 x 4"
70 ea. 17138-1025 T25 Deck Screw, #10 x 2-1/2"
2 ea. 17036-1002 Lag Screw 5/16 x 2-1/2"
2 ea. 14161-400
Access Ladder Bracket
1 ea. 50277-100
Rock Pack (12)
(12 ea. 15090-400
Climbing Rocks)
Weld Nut
Lock Washer
Flat Washer
Hex Bolt
Deck Screw
Lag Screw
Access Ladder
Bracket
MODEL #AH 201-102Q
ASSEMBLY MANUAL
A
E
C
D
F
B
COMPONENT PARTS
