Made in Indonesia- r01
Page 3 of 4
SLOANE
GREY/MAHOGANY LEANING BOOKCASE
A
wall fitting &
small screw
SAFETY MOUNTING ASSEMBLY
For added safety and stability, it is recommended that the wall mounting
hardware be installed. For safe mounting, it is essential to use wall
anchors appropriate to your wall type (i.e. plaster, drywall, concrete, etc.).
Mount to wood studs whenever possible.
A) Attach 1
wall fitting to assembled unit as shown, using 1 small
screw.
B) Determine the final location of shelving unit. Mark position on the
wall, approximately 2" below the bracket mounted to the back of the unit.
C) Drill a hole in the wall stud. If the wall stud is not available, drill a hole
in the wall that is slightly smaller in diameter than the anchor. Gently tap
the
plastic anchor until the flange of the anchor is flush with the wall.
D) Attach the
wall fitting to the wall by inserting 1 large screw through
the wall fitting and into the plastic anchor in the wall.
E) Place the unit so the wall fitting on the back edge is aligned with the
wall fitting on wall.
F) Lace one end of the
wall strap through both fittings, and into the
other end of the strap.
G) Pull the strap tightly until secure.
Mounting assembly is now complete.
NOTE:
If you are unsure about your
wall type or what mounting
method you should use,
consult a qualified
professional or your local
hardware store.
C
F
wall strap
plastic
anchor
D
large screw
Customer Service
800.967.6696 | Latest instructions available at www.crateandbarrel.com
