Crane Frozen Gourmet, Инструкция по установке и эксплуатации

Страница: 34 / 44

Frozen Gourmet Setup and Operators’ Guide
28 4550001
1. Install the Lock Cylinder:
Install an optional lock cylinder in the merchandiser as follows:
a. Position the lift handle lock lever as shown.
b. Depress the lock spring at the square hole of the lock cylinder receptacle and
pull the lock springs out through the front.
c. Position the lock cylinder as shown. Depress the spring loaded lock pin.
d. Push the cylinder into the cylinder receptacle in the lever. The pin should snap
into the square hole.
e. If the cylinder pin does not seat in the square hole, press against both ends of the
lock cylinder. Rotate the cylinder until the pin snaps into place.
f. Leaving the door open, test the lock mechanism with a key.
2. Install the Optional Cash Box Lock:
a. Remove the cash box from the merchandiser.
b. Assemble the lock as shown in the illustration below.
c. Return the cash box to the merchandiser.
3. Load the Coin Mechanism:
a. Insert coins one at a time until each of the coin tubes has been filled.
b. Inspect the tubes for coins that are not stacked squarely and correct if necessary.
Accessories
LOCK
SPRING
KEY
LOCK
CYLINDER
LEVER
SQUARE
HOLE
The optional door locks available from
Crane Merchandising Systems are listed
below:
Flex-Ace (P/N 9992000)
•
Corresponding key (P/N 9994000)
Van Lock (P/N 3112163)
•
Corresponding key (P/N 3112164)
• Kit-lock and key (P/N 3112165)
LOCK BAR
SCREW
NUT
WASHER
LOCK
CYLINDER