Crane DEMING 7365 Series, Инструкция по установке и эксплуатации

Страница: 14 / 24

14
Make sure the stationary member is in straight and that
the rubber ring is not out of it’s groove. Lightly oil (DO NOT
use grease) shaft and inner surface of bellows on rotating
member (4B) see Figure 8. With lapped surface of rotating
member (4B) facing inward toward stationary member (4A),
slide rotating member (4B) onto shaft using a seal pusher,
until lapped faces of (4A) and (4B) are together.
(See Fig. 7).
IMPORTANT ! - It is extremely important to keep
seal faces clean during assembly. dirt particles
lodged between these faces will cause the seal to
leak.
Place spring (4C) over shaft and in place on rotating member
(4B), making sure it is seated on retainer and not cocked or
resting on bellows tail. Slide retaining ring (5) over shaft and
let rest on spring (4C). Replace snap ring onto motor shaft.
Inspect gasket (9) and replace if cut or damaged. Assemble
impeller and volute as outlined in paragraph E-2.2.
SECTION: F REPLACEMENT PARTS
F-1 ORDERING REPLACEMENT PARTS:
When ordering replacement parts, ALWAYS furnish the
following information:
1. Pump serial number and date code. (Paragraph F-4)
2. Pump model number. (Paragraph F-3)
3. Pump part number. (Paragraph F-2)
4. Part description.
5. Item part number.
6. Quantity required.
7. Shipping instructions.
8. Billing Instructions.
F-2 PART NUMBER:
This number is used for ordering and obtaining information.
F-3 MODEL NUMBER:
This designation consists of numbers and letters which
represent the discharge size, series, horsepower, motor phase
and voltage, speed and pump design. This number is used for
ordering and obtaining information.
F-4 SERIAL NUMBER:
The serial number block will consist of a six digit number,
which is specific to each pump and may be preceded by
an alpha character, which indicates the plant location. This
number will also be suffixed with a four digit number, which
indicates the date the unit was built (Date Code). EXAMPLE:
A012345 0490 .
Reference the six digit portion (Serial Number) of this number
when referring to the product.
FIGURE 5
FIGURE 6
Stationary Member (4A) Pol-
ished Face Out
Motor Mounting Plate
Seal Pusher
FIGURE 7
Rotating Member (4B)
Bullet
Motor
Seal Pusher
Stationary