Page
12
of
52
to the Vender and allow it to run for several hours with the glass
door closed or until the minimum cabinet
temperature is achieved. Then, using the method below, verify the temperature inside the Machine.
With an electronic Encapsulated Temperature Sensor, use the Keypad on the Service Door to show cabinet
temperature in Fahrenheit by pressing the F Key followed by the asterisk (
) Key or in Centigrade by pressing the
C Key followed by the asterisk (
) Key. The temperature will be shown on the digital Display located on the front
of the Service Door.
The manual Defrost Thermostat is located in the bottom left of the service area. The Defrost Thermostat is preset
and is not adjustable.
LOADING THE VENDER
CAN/BOTTLE DRINK TRAYS
The BevMax 4 5800-4/3800-4 Vender does not require spacers or shims to vend most packages. Load product in
each column one package at a time insuring that the package being loaded is in front of the product pusher. Insure
that the package is stable within the column (doesn’t move excessively from side to side). After loading the
Vender, test vend each column to insure proper operation. Please contact a Service Representative or refer to
the proper Technical Publication for any special settings you may need.
LOADING COIN CHANGER TUBES
The Coin Changer tubes can be loaded using one of the following methods:
1.
Load the Coin Changer with coins to the desired level by inserting coins in the loading slots on the coin
tube front.
Minimum coin tube levels are:
6-8 nickels
7-8 dimes
5-6 quarters
Note: A low coin level in the coin tubes will interfere with operation of the Bill Acceptor.
2.
For exact cash accountability and to insure maximum dollar bill acceptance, load the Coin Changer utilizing
the coin insert slot on the front of the Vender while in the coin TUBE FILL/DISPENSE mode in the Test
Mode. Refer to the INITIAL PROGRAMMING section of this guide for more information.
For additional information about Coin Mechanism, refer to the manufacturer’s instructions.
COMPONENTS
OMRON POWER SUPPLY 24V 150W
The New 24V 150W Omron Power Supply is located inside the service area, mounted to the
back wall below the AC Distribution Box. It has 3 outputs with each one being capable of 150W.
Two of the outputs are wired into the AC Distribution Box. Each of the outputs are fused at
75W by the circuit breakers in the AC Distribution Box Assembly. It contains a Board with Green
Status Light that illuminates when power is present. This 24V 150W Power Supply is common
across all New Electronics Platform BevMax Refresh Domestic, Export, Classic (BevMax 4), and
Media (BevMax 6) models. The Power Supply receives AC voltage via the AC Distribution Box.
The Power Supply converts the AC voltage to the main operating DC voltages of the Vender
(24VDC).
Содержание 3800-4
Страница 1: ......
Страница 2: ...Page 2 of 52 ...
