4
VOCE Media
S
ec
ti
o
n
2
– In
stalla
ti
o
n
VOCE Media
Section 2 – Installation
Important!
It is essential that any other personnel responsible for installing and
servicing your machine understand the following:
1.
The installation and commissioning of your machine should
only
be carried out by a
trained and authorised service engineer
.
2.
All water and electrical services must be correctly and safely connected in compliance
with national and local regulations.
3.
All covers must be replaced securely and the machine left in a safe condition.
2.1 Siting your Machine
1.
Your machine is suitable for indoor use only. We recommend that it be situated in an
area with an ambient temperature not below 10
º
C and not exceeding 30
º
C. Your
machine should be located near the appropriate water and electrical.
2.
Prior to placing your machine in its final location, ensure that there is sufficient access
space available via passageways, stairs, lifts, etc.
3.
To ensure adequate ventilation, 100 - 150 mm (4 - 6 inches) clearance must be
allowed between the back of the cabinet and the wall.
4.
Remove all transit packing, installation kit. Check for visual signs of damage which
may have occurred during transit. If your machine is damaged or any parts are
missing, you must contact the supplier immediately.
5.
Level your machine by adjusting the feet.
6.
Ensure that the door opens and closes easily.
2.2 Connecting the Water Supply
1.
Your machine should be situated within 1 metre of a drinking water supply from a
rising main, terminating with a stop-tap with 15mm outlet pipe.
N.B.
The water supply should comply with national and regional regulations. (eg in
the U.K. the Statutory Instrument No.1147 - “Water, England and Wales” and The
Water Supply (Water Quality) Regulations 1989.
Dynamic water pressure at the stop-tap must be within the limits 2 - 6 Bar (200 Kpa -
600 Kpa).
2.
Connect the flexi-hose (supplied with your machine) to the water supply. Flush the
system thoroughly before connecting to the machine.
N.B.
When connecting your machine to the water supply always use a new flexi-hose.
3.
Ensure that the seal is correctly fitted. Ensure that all water supply fittings are tight.
4.
Turn on the water supply at the stop tap and check for leaks.
