Using N22H with Camden EC2
C.A.S.T. comes alive when you start to pair it with other Cranborne Audio products. Products
such as Camden EC1/EC2 and 500R8/500ADAT are all designed to facilitate deep integration
into the C.A.S.T. system for useful routing around your studio space.
This hardware setup diagram will get N22H connected within a C.A.S.T. enabled system
alongside a Camden EC2 and a passive N22 breakout box for advanced remote recording and
monitoring possibilities.
Connecting N22H to Camden EC2
1. Connect N22H’s C.A.S.T. Output [13] to the C.A.S.T. Input on Camden EC2 using a
shielded Cat 5e, Cat 6, or Cat 7 cable.
i.
Note: A fully shielded connector is required in order to pass 48v correctly.
2. Connect Camden EC2’s C.A.S.T. Output to the C.A.S.T. Input on N22 using a shielded Cat
5e, Cat 6, or Cat 7 cable.
3. On N22H, set the Source Switch [6] to C.A.S.T. and connect your headphones to the
Headphone Output [2].
i.
If using battery power, the unit will power on automatically when headphones are
connected.
ii.
If using mains power, N22H powers on automatically when power is detected.
4. On Camden EC2, set the rear panel Source Switches for each Preamp to C.A.S.T. to
enable Camden EC2’s preamps to receive their input via the C.A.S.T. connection.
5. Connect balanced Mic/Line sources to either of N22H’s Inputs [4]
i.
If you’d like to connect an instrument, you will need to either use a DI Box, or
connect an instrument directly to Camden EC2’s Hi-Z DI Input.
Camden EC2 User Manual
-Page 31-
©2020 Cranborne Audio Ltd
