Signal Indicator [F3]
The signal indicator [F3] is a visual aid to help achieve the
best performance and highest possible signal-to-noise
ratio during the recording process. Correct gain staging
will also get Mojo working at its best.
The signal LED is an RGB LED and is calibrated to have the
following thresholds for input level:
Blue
-40dBu to -1dBu
Green
0dBu to +20dBu
Amber
+21dBu to +23dBu
Red (clip)
+24dBu
Tip:
To get the maximum effect out of Camden EC2’s Mojo control, the Gain
Control should be run as high as possible without the Signal Indicator
lighting RED.
48v Switch [F8]
The 48v switch [F8] engages 48v phantom power and
sends supply voltage down pin 1 of the chassis’ XLR input
socket to power condenser microphones and Di boxes if
required. Phantom power is off when in the ‘up’ position.
Phantom power is on and ready when in the ‘down’
position and the LED is lit up red.
Note:
Do not engage 48v with vintage ribbon mics
connected to Camden EC2 as sending voltages
through to the ribbon can cause permanent
damage to the microphone.
Be careful when connecting line-level
instruments (such as interfaces, keyboards) to
Camden EC2 via XLR when 48v is engaged. Sending 48v through to the line-level
outputs of instruments and playback devices can cause irreparable damage to
their internal components and is not covered under warranty.
Camden EC2 User Manual
-Page 18-
©2020 Cranborne Audio Ltd
