Rev 03
CCCS Install Manual
7
Center Gate Shield
Provided with the system are 2 plastic
shields and self-tapping screws. These
are used to fill the gaps between the bi-
fold gates. They should be mounted on
the rear angle of both front bi-fold
gates, flush with the top of the gates.
These must be mounted to front gate
assemblies to prevent wind damage. A
small gap must remain between the
bottom edge of the shield and the top
of the locking device mast to allow the
pivoting lock plates to function.
Lights and Reflective Tape (To Meet Federal Lighting Standards)
1.
Reflective tape is required on the rear top corners of the bulkheads.
2.
Amber lights are required at the top corners in the front.
3.
Red lights are required at the rear top corners, and the triple light bar is required at the center top
rear. Access holes are precut in bulkhead tubes to help facilitate wiring.
Images shown
without required
reflective tape
