7
English
Attaching Spool Assembly (Fig. B, C)
1. Install spindle plate
22
onto the spindle
23
, so the
double D shaped retaining nut on the spindle sits inside
the base of the spindle plate.
2. Rotate the spindle plate until the hole
24
aligns with
notch
25
in the housing. Insert the included rod
through the notch and into the hole, to prevent the
spindle from turning.
3. While holding the rod in place, thread the new spool
housing
10
with spool grip cover counterclockwise.
Securely tighten the new spool housing onto
the spindle.
Fig. B
23
10
24
25
22
Fig. C
23
Attaching Guard (Fig. D, E)
WARNING:
Never remove the guard.
Damage or personal injury could result.
WARNING:
NEVER OPERATE
APPLIANCE WITHOUT GUARD FIRMLY IN PLACE.
The guard must always be properly attached on the
appliance to protect the user.
1. Assemble the guard
9
to the motor housing
5
.
2. Using a cross head screwdriver, insert the 2 guard
screws
15
and tighten securely.
nOTE:
An extended coverage guard is available (sold
separately) for extra coverage if desired. Use CRAFTSMAN
replacement guard Part Number N636336.
Fig. D
5
Fig. E
15
9
Adjusting the Auxiliary Handle (Fig. F)
The auxiliary handle
4
is positioned to maximize balance.
However, if adjustment is necessary, flip open the latch
21
and slide the auxiliary handle
4
up or down the upper
trimmer pole
6
.
21
6
4
Fig. F
OPERATION
WARNING:
To reduce the risk of
serious personal injury, turn unit off and
