ENglISh
4
OPERATION
FLOW CONTROL LEVER
ADJUSTABLE STOP
WING NUT
Adjusting the Flow Rate Setting
•
Loosen the wing nut that fastens the flow control lever
to the handle.
•
Slide the adjustable stop to the desired setting and
retighten the wing nut. See figure 9.
Spreading Material
•
Check the material package for the proper spreader
setting and application rate.
•
Before filling spreader, move the control lever to the
"OFF" position.
•
Move spreader onto a flat surface - either a walk or a
driveway - and fill.
•
Slide the adjustable stop to the desired setting.
•
Start the spreader in motion, then move the control
lever forward against the adjustable stop to begin
spreading.
•
NOTE: Always place control lever in the "OFF" position
while filling spreader and when stopping or turning, to
prevent release of excess fertilizer..
•
DO NOT EXCEED 6 MPH WHILE TOWING SPREADER
Application Tips
•
This unit will cover a 4 to 8 foot wide area depending on
the material used and the towing speed.
•
To avoid misses or striping, make each pass about 5 feet
from the previous one so some overlapping of spread
pattern does occur.
•
For easiest application, spread across the shortest edges
of lawn first, making two "header" strips for a turning
area, and then spreading between the header strips.
See figure 10.
•
If lawn is odd shaped, spread a border around the edges
and then spread between the border. See figure 10.
•
Keep wheel approximately 4 feet from any area you do
not wish to spread.
•
IMPORTANT: Be careful when using spreader around
ornamental plants because weed control chemicals can
damage these plants.
Fig. 9
Fig. 10
MAINTENANCE
Check For Loose Fasteners
•
Make a thorough visual check of the Spreader for any
bolts and nuts which may have loosened. Retighten any
loose bolts and nuts.
Cleaning & Storage
•
Always empty spreader after each use, storing leftover
material in it's original bag.
•
Wash the spreader and dry thoroughly after each use.
•
Store in a dry area.
Lubrication
•
Apply a few drops of oil to all moving parts....
IMPORTANT: Minor setting adjustments may be necessary
to compensate for humidity and moisture content of the
material.
TYPE
MATERIAL
FLOW
SETTING
SPREAD
WIDTH
FERTILIZER
Granular
3 - 5
8' - 10'
Pelleted
3 - 5
10' - 12'
GRASS
SEED
Fine
3 - 4
6' - 7'
Coarse
4 - 5
8' - 9'
ICE MELTER
6 - 8
10' - 12'
APPLICATION CHART