CAUTION:
To avoid damage to the
impeller and motor, always reinstall the
reusable filter before using the vacuum for dry
pickups and always reinstall the foam filter before
using the vacuum for wet pickups.
CAUTION:
After cleaning, check the
filter for tears or small holes. Do not use a filter
with holes or tears in it. Even a small hole can
cause dust to come out of the vacuum. Replace
it immediately.
CAUTION:
Clean the filter in an
open area.
6
To keep the wet/dry vacuum looking its best, clean the
outside with a cloth dampened with warm water and
mild soap.
To clean the tank:
1 . Dump out debris.
2 . Wash tank thoroughly with warm water and
mild soap.
3 . Wipe out with dry cloth.
WARNING:
To reduce the risk of injury
from accidental starting, unplug power cord before
changing or cleaning filter. The filter should be
cleaned often to maintain peak Vacuum
performance.
WARNING:
Do not remove filter cage
and float. The float prevents water from entering
the impeller and damaging the motor. The cage
prevents fingers from touching the moving impeller.
CLEANING
Before storing the vacuum, the dust tank should be
emptied and cleaned. The cord should be wrapped
and hung on the unit and the accessories should be
kept in the accessory holder so they can be readily
available. The vacuum should be stored indoors.
STORAGE
FILTER REPLACEMENT
ENGLISH
CARE AND MAINTENANCE
Accessories
WARNING:
Since accessories, other than
those offered by CRAFTSMAN,
have not been tested
with this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
CRAFTSMAN recommended accessories should be
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact CRAFTSMAN, call
1-888-331-4569
.
Vacuum will not run
Loss of suction,
wet pick-up
Loss of suction, dry
pick-up
No electricity
Make sure electrical outlet has voltage
(A qualified electrician may need to be
contacted)
1) Drain and clean tank
2) Remove hose and clean debris
3) Clean or replace filter
1) Drain and clean tank
2) Remove hose and clean debris
3) Clean or replace filter
1) Full tank
2) Clogged hose
3) Clogged filter
1) Full tank
2) Clogged hose
3) Clogged filter
BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS
PROBLEM
POSSIBLE CAUSE
SOLUTION
TROUBLESHOOTING GUIDE
Minor problems often can be fixed without calling customer service.
