Craftsman CMXEVCVVJF910, Инструкция по эксплуатации

Страница: 5 / 40

5
ENGLISH
2. Lift the power head 11 off the collection
tank 9 .
3. Remove the contents from inside the
collection tank 9 ; make sure you have all
contents as listed on page 2.
ASSEMBLY
Caster System Assembly
4. Turn the collection tank upside down and
insert the four caster feet 6 into the slots
on the collection tank and tighten with
supplied screws
14 . Verify that the caster
feet 6 are mounted correctly. Do not over-
tighten screws. Fig. 1 .
Fig. 1
GENERAL SET UP
5. Your vacuum comes ready for dry vacuum
cleaning. If the cartridge filter is not
installed, refer to page 6-7 for installation
instructions.
6. For wet vacuum cleaning, remove the
cartridge filter, and install the supplied foam
wet filter. See page 8 for the foam wet filter
installation instructions.
7. Place the power head back on the collection
tank and secure into place using the latches.
8. Insert the larger end of the hose 15 into the
vacuum port on the collection tank 9 and
lock into place. Fig. 2 .
Fig. 2
9. Choose the desired accessory 17 18 and/or
extension wands 16 and insert onto the end
of the hose 15 . Fig. 3 .
Fig. 3
10. Plug the power cord into the outlet.
Turn the motor on by flipping the on/off
switch
12 to the ‘I’ ON position and begin
vacuuming. Fig. 4 .
Fig. 4
WARNING:
ONCE YOU HAVE
COMPLETED VACUUMING, FLIP THE ON/
OFF SWITCH TO THE ‘O’ OFF POSITION AND
UNPLUG THE POWER CORD FROM THE
OUTLET. O = OFF I = ON
BLOWER OPERATION
This Wet/Dry Vacuum has blowing capabilities.
To use the blower feature follow the instructions
listed.
WARNING:
ALWAYS WEAR
SAFETY GOGGLES COMPLYING WITH ANSI
Z87.1 (OR IN CANADA, CSAZ94.3) WHEN
USING BLOWER.
WARNING:
KEEP BYSTANDERS
CLEAR FROM BLOWING DEBRIS.