Craftsman CMXEVCVVJC809, Инструкция по эксплуатации

Страница: 5 / 40

5
ENGLISH
2. Lift the power head 2 off the collection
tank 8 .
3. Remove the contents from inside the
collection tank 8 ; make sure you have all
contents as listed on page 2.
ASSEMBLY
Caster System Assembly
4. Turn the collection tank upside down and
insert the four caster feet 5 into the slots
on the collection tank and tighten with
supplied screws
12 . Verify that the caster
feet 5 are mounted correctly. Do not over-
tighten screws. Fig. 1 .
Fig. 1
Handle Assembly
5. Insert the handle 11 into the slots located
on the top of the power head 2 and secure
it with the screws 12 provided. Do not over-
tighten screws 12 . Fig. 2 .
Fig. 2
Fig. 3
GENERAL SET UP
6. Your vacuum comes ready for dry vacuum
cleaning. If the cartridge filter is not
installed, refer to page 7 for installation
instructions.
7. For wet vacuum cleaning, remove the
cartridge filter, and install the supplied foam
wet filter. See page 8-9 for the foam wet
filter installation instructions.
8. Place the power head back on the collection
tank and secure into place using the latches.
9. Insert the larger end of the hose 13 into the
vacuum port on the collection tank
8
and
lock into place. Fig. 3 .
10. Choose the desired accessory 15 16
and/or extension wands 14 and insert onto
the end of the hose
13
.
Fig. 4.
Fig. 4
11. Plug the power cord into the outlet.
Turn the motor on by flipping the on/off
switch
10 to the ‘I’ ON position and begin
vacuuming. Fig. 5 .