0
0
1
1
2
3
4
5
6
7
8
9
10
2
3
4
5
6
7
8
9
10
11
12
0
0
1
1
2
3
4
5
6
7
8
9
10
2
3
4
5
6
7
8
0
0
1
1
2
3
4
5
6
7
8
9
10
2
3
4
5
6
7
8
ENGLISH
19
•
Loosen the rip fence by lifting the locking handle
up.
•
Move the rip fence to the desired distance from the
blade and ensure the rip fence is level on the working
table.
•
Push the locking handle down to secure the fence.
When securely locked, the locking handle should point
downward.
When ripping a narrow workpiece, it is necessary to attach
the sub fence assembly to the rip fence to prevent hands
from getting too close to the blade.
•
Pull up the locking knob on the sub fence assembly
.
•
Align the slot of sub fence assembly with the rip
fence , and push the sub fence assembly down.
•
Lock it in place by pushing down lock knob .
•
Sub fence assembly can be mounted on left or right
side of the rip fence .
•
When not in use, store the sub fence assembly in
storage position.
Use sub fence assembly (for rip cutting narrow
workpiece) (Fig. 19b)
1
3
2
4
2
3
1
1
2
Fig. 17
Fig. 18
Fig. 19a
WARNING:
Make sure the blade guard is in place
after adjusting the blade depth. Failure to heed this
instruction could result in serious personal injury.
Blade depth should be set so that outer points of blade
are higher than workpiece by approximately 1/8 in. (3 mm)
to 1/4 in. (6 mm) and bottom of gullets are below top
surface of workpiece. (Fig. 15)
• Turn the bevel locking lever
clockwise to tighten it
securely.
• Raise blade
by turning height adjusting handle on
the height/bevel adjusting handwheel clockwise.
Lower blade by turning height adjusting handle
counter-clockwise.
• Make sure blade
is at proper height.
Changing blade depth (Fig. 15, 17)
1
2
1
1
1
•
Loosen the bevel locking lever counter-clockwise.
• Adjust bevel angle by first pushing height/bevel
adjusting handwheel all the way to the left.
• Holding height/bevel adjusting handwheel, slide bevel
indicator to the right to increase angle of blade
(bringing it closer to 45° from the tabletop). Holding
height/bevel adjusting handwheel, slide bevel indicator
to the left to decreases the angle (bringing blade closer
to 90° from the tabletop).
• Make sure blade
is at desired angle. Tighten bevel
locking lever clockwise.
1
1
2
3
3
1
2
1
2
2
3
3
2
1
2
2
3
4
3
WARNING:
To reduce the risk of injury, always make
sure the rip fence is parallel to the blade before
beginning any operation.
Rip fence (Fig. 19a-19b)
CAUTION:
A 90° cut has a 0° bevel and a 45° cut has
a 45° bevel.
CAUTION:
If bevel indicator is not at zero when saw
blade is at 0°, see the section “To adjust bevel
indicator”.
Changing blade angle (bevel) (Fig. 18)
