5
English
Cleaning
WARNING:
Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this.
WARNING:
Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of the
work light. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid get
inside the work light; never immerse any part of the
work light into a liquid.
Repairs
This work light is not serviceable. There are no serviceable
parts inside the work light.
Accessories
WARNING:
Since accessories, other than those
offered by CRAFTSMAN, have not been tested with
this product, use of such accessories with this product
could be hazardous. To reduce the risk of injury, only
CRAFTSMAN recommended accessories should be
used with this product.
WARNING:
To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
Place work light on a stable surface where it will not
cause a tripping or falling hazard. Work lights may be
easily knocked over in certain situations.
Recommended accessories for use with your work light are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact CRAFTSMAN, call 1-888-331-4569
Tripod (Sold Separately) (Fig. H)
This work light is compatible with Craftsman
CMXELAYMPL1031 tripod (Sold Separately)
.
It is for use as a
single light configuration when using the tripod. For details,
please visit www.craftsman.com or visit your local dealer.
Fig H.
Condition
Maximum Plug Current
allowed
With light on and USB port is occupied
9A
With light off and USB port is not occupied 10A
Fig F.
3
4
Light Switch and Master Switch (Fig. A, G)
Press Light Switch
6
towards “I” to turn on the work light,
Press Light Switch
6
towards “o” to turn off the work light.
When the fixture is overloaded, Master Switch
7
will be
turned off automatically. Disconnect the devices and press
Master Switch
7
towards "ON" to use the fixture.
Fig G.
7
6
CARE AND MAINTENANCE
WARNING: To reduce the risk of serious personal
injury, turn unit off, disconnect it from power
source and put it on a stable secure position
before making any adjustments or removing/
installing attachments or accessories.
WARNING:
When performing maintenance, you may
be exposed to voltage sources. Personal injuries can
occur. Before performing any maintenance, disconnect
work light from power source.
