Craftsman C459-62102, Руководство оператора

Страница: 13 / 72

13
OPERATION
To engage DriVe & TineS
1. For forward motion of the wheels and power to the tines pull the
Forward Clutch Bail up against the handlebar.
2. When tilling, relax and let the wheels pull the machine while the
tines dig. Walk slowly behind the tiller allowing it to move at its
own pace while keeping a secure grip on the handlebar with your
elbows flexed.
3. Release the bail to stop the forward motion of wheels and tines.
TUrning The Tiller
1. Practice turning the tiller in a level, open area. Be very careful to
keep your feet and legs away from the tines.
2. To begin a turn, lift the handlebars until the tines are out of the
ground and the engine and tines are balanced over the wheels.
3. With the tiller balanced, push sideways on the handlebar to steer
in the direction of the turn. After turning, slowly lower the tines into
the soil to resume tilling.
SeTTing The DePTh
yoke forward
Attach the wheel yoke so that the wheels are forward (nearest to tines)
for shallow tilling, cultivating and transport by removing the clevis pin
and cotter pin. See Figure 14.
To STarT engine
1. Attach spark plug wire and rubber boot to spark plug.
2. Fill tank to no more than 1/2 inch below bottom of filler neck to
provide space for fuel expansion.
3. Make sure the tine clutch control is disengaged.
4. Move the choke lever on the engine to CHOKE
position. (A
warm engine may not require choking.) See Figure 13.
5. Move throttle control to START/RUN (Rabbit) position. See
Figure 13.
6. Standing on the side of the unit, grasp starter handle and pull
rope out until you feel a drag.
7. Pull the rope with a rapid, continuous, full arm stroke. Keep a firm
grip on the starter handle. Let the rope rewind slowly.
8. Repeat, if necessary, until engine starts. When engine starts,
move choke control gradually toward the RUN position..
9. If engine falters, move choke control back toward the CHOKE
position and repeat steps 5 though 8.
10. ALWAYS keep the throttle control in the START/RUN (Rabbit)
position when operating the tiller.
To SToP engine
1. To stop the wheels and tines, release the Forward Clutch Bail.
2. Move throttle control lever to slow (turtle)
position.
Whenever possible, gradually reduce engine speed before
stopping engine.
3. Move throttle control lever to STOP or OFF position.
4. Disconnect spark plug wire and ground it against the engine to
prevent accidental starting while the equipment is unattended.
STOP
Figure 13
wheel
wheel Yoke
Figure 14