5
When using an extension cord, be sure to
use one heavy enough to carry the current
your product will draw. An undersized
cord will cause a drop in line voltage
resulting in loss of power and overheating.
The following table shows the correct
size to use depending on cord length and
nameplate ampere rating. If in doubt, use
the next heavier gauge. The smaller the
gauge number, the heavier the cord.
SAve TheSe INSTRUCTIONS
Safety Warnings and Instructions
WARNING:
To reduce the risk of serious personal injury,
read, understand and follow all
safety warnings and instructions prior to using tool.
ReAD All INSTRUCTIONS
Minimum Gauge for Cord Sets
volts
Total length of Cord in feet
120V
0-25
26-50
51-100
101-150
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
240V
0-50
51-100 101-200
201-300
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Ampere Rating
More Not more
American Wire Gauge
Than Than
0 - 6
18
16
16
14
6 - 10
18
16
14
12
10 - 12
16
16
14
12
12 - 16
14
12
Not Recommended
1. Power Unit
2. Forward/reverse slider
3. Variable speed trigger
4. Attachment release button
5. Drill attachment
6. Keyless chuck
7. Torque adjustment collar
6
7
5
PARTS AND feATUReS
2
3
4
1
OPeRATING: POWeR UNIT
TRIGGeR SWITCh & fORWARD/ReveRSe SlIDeR
The Power Unit’s (1) forward/reverse slider (2) is used to control the direction the chuck (6) spins:
Forward to drive screws; Reverse to remove screws. It is located above the variable speed trigger (3).
After any operations, return lever to the forward position. Never change the direction of rotation while
the motor is running.
• The Power Unit is turned ON and OFF by pulling and releasing the trigger. The more the trigger is
pulled, the higher the speed of the Power Unit.
• A forward/reverse control slider determines the direction of the tool.
• To select forward rotation, release the trigger switch and depress the forward/reverse control
button to the left.
Содержание Bolt-On 35592
Страница 16: ......
