Connect Hoses and Water Supply
NOTICE
Use ONLY cold water (less than 100°F).
1. Attach garden hose (50 ft. / 15.24 m maximum) to water
supply.
2. Run water through garden hose for 30 seconds to flush the
hose of debris. Turn off water.
3. Confirm that water inlet screen (A) is installed in water inlet
located at left side from front of unit; Do Not remove except
for cleaning.
NOTICE
If inlet screen is damaged or missing, DO NOT use elec-
tric pressure washer. Call 1-866-902-9690 for assistance.
NOTICE
DO NOT run the pump without the water supply connect-
ed and turned on. Damage to equipment resulting from failure to
follow this instruction will void warranty.
• Attach opposite end of garden hose (B) to the water inlet
coupling (C). Tighten by hand
• Pull out a length of the high pressure hose from the hose
reel. Attach the hose end to the spray gun. Twist the nut (F)
of the hose onto the gun (G) by hand.
Connect Wand and Spray Tip
1. Turn ON water, point gun in a safe direction, press trigger
lock button (H) to release trigger, then squeeze trigger (J) to
purge pump system and spray gun of air and impurities.
• Insert and twist plastic wand (K) into spray gun (M). Once
• wand slides into gun, apply further inward pressure to wand
and twist 1/4 turn clockwise until securely in place.
• Turn OFF water and release trigger. Point gun in a safe direc-
tion and make sure trigger is locked and can’t be squeezed.
• Insert the spray tip (N) into plastic wand (P). Once spray tip
slides into gun, apply further inward pressure until it SNAPS
into place.
3.
4.
2.
1.
4.
5.
7
J
H
K
C
A
B
N
P
M
