13- ENG
D30339
D30339
2.
Remove filler cap/dipstick and
add engine oil (supplied) to
engine.
NOTE:
There will be a slight amount
of oil in the engine from factory
testing.
3.
Oil level should be at the FULL
line on dipstick. Always check oil
level before each start-up.
4.
Verify the filter screen is in water
inlet of pump, as shown.
5.
Connect high pressure hose to
pump outlet.
6.
Connect water source to pump
inlet.
NOTE: Water source must provide
a minimum of 5 gallons per minute
at 20 p.s.i.
Water
Source
High
Pressure
Hose
Filter Screen
BEFORE STARTING
Read and understand all Important
Safety Instructions in the front of
this manual and the following
Cautions and Warnings before
starting the pressure washer.
•
Never fill fuel tank completely.
Fill tank to 1/2" below bottom
of filler neck to provide space
for fuel expansion. Wipe any
fuel spillage from engine and
equipment before starting
engine.
•
Never fill fuel tank indoors.
Never fill fuel tank when engine
is running or hot. Do not
smoke when filling fuel tank.
•
Never run engine indoors or in
enclosed, poorly ventilated
areas. Engine exhaust con-
tains carbon monoxide, an
odorless and deadly gas.
•
Never turn water supply off
while pressure washer engine
is running or damage to pump
will result.
•
DO NOT use hot water, use
cold water only.
•
DO NOT stop spraying water
for more than two minutes at a
time.
NOTE:
Remove and discard blue
plug in fuel fill.
1.
Add fresh high quality unleaded
gasoline with a pump octane
rating of 86 or higher. Do not
overfill. Wipe up spilled fuel
before starting the engine.
Filler cap/
dipstick
Fuel
Fill
