Craftsman 919.155350, Руководство пользователя

Страница: 5 / 18

TO USE
1. Mix material according to the
manufacturer’s instructions. Mixture
should be smooth and easily pourable.
Lumps or foreign particles should be
removed by straining through a
suitable paint filter.
NOTE: If not using the siphon feed setting,
see “Remote Pressure Feed” paragraphs.
2.
Remove the material cup (e) from
lid/gun assembly. NOTE: Slide release
lever (f) to the right, rotate lid, and
remove
material cup (e).
3. Fill the material cup (e) 3/4 full.
4. Attach material cup (e) to the lid/gun
assembly and slide release lever (f) to
the left to secure in place.
5. Attach air supply line to 1/4 NPT air
inlet (c).
6. Adjust spray pattern.
a. The position of the air cap
horns (g) will
determine the spray pattern. Loosen air
cap (h) and rotate horns to achieve
desired pattern. Tighten air cap.
7. Turn fluid control knob (b) clockwise until it
stops, do not force. This will shut off the fluid flow. NOTE: The fluid or den-
sity of “fan spray” is controlled by fluid control knob (b) .
8. Adjust air pressure to 60 psi at air compressor.
DO NOT exceed 100 psi.
9. Turn air valve control knob (a)
counterclockwise until first thread is flush with
gun body.
NOTE: Air flow is controlled by air
valve control knob (a) . DO
NOT turn air valve
control knob or fluid control knob out until
the first thread is past the gun body. They
are under pressure when the gun is triggered
and could leave the gun with force.
NOTE: Care should be exercised when handling
spray gun to avoid damage to the orifice of the air cap and tip of fluid nozzle.
Damage to these parts results in irregular spray patterns.
9. Depress spray gun
trigger (d) and gradually turn the fluid control knob (b)
counterclockwise until desired fluid flow is reached. Trigger gun quickly, on
second on-off to test pattern.
NEVER point spray gun at self or any other person. Ac-
cidental discharge of material may result in serious
injury.
NOTE: If gun sprays too fast, decrease the air and fluid pressure. If too slow,
increase the pressure. Turn fluid control knob (b) counterclockwise to increase,
or clockwise to decrease, the fluid flow. Turn air valve control knob (a) counter-
clockwise to increase, or clockwise to decrease, the air flow.
5- ENG
D25867
e
f
a
b
g
c
d
h
Horizontal position
Vertical position
a
b
first thread flush