Craftsman 917.37707, Руководство пользователя

Страница: 7 / 22

7
TO ASSEMBLE GRASS CATCH ER
1. Put grass catcher frame into grass bag with
rigid part of bag on the bottom. Make sure
the frame handle is outside of the bag top.
2. Slip vinyl bindings over frame.
NOTE : If vinyl bindings are too stiff, hold
them in warm water for a few minutes. If
bag gets wet, let it dry before using.
TO PREPARE BATTERY
NOTE:
Your battery must be charged
before you can start your lawn mower.
1. Con nect battery charger con nec tor
(male) to harness con nec tor (fe male).
2. Plug battery charger into 110 volt A.C.
outlet.
3. Leave battery charger connected for
24 hours before starting your engine
for the fi rst time.
4. After charging, disconnect harness
connector (female) from bat tery char-
ger connector (male).
Connect your battery charger to charge
battery after each use.
IMPORTANT: The engine will not re-
charge your battery.
At the end of the mowing season the
battery should be charged for 48 hours to
protect the battery during winter storage.
CAUTION: Always disconnect the
en gine connector (male) from the battery
connector (female) to prevent ac ci den tal
start ing when transporting or stor ing your
lawn mower after the season.
Frame
handle
Frame
opening
Vinyl
bindings
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to be
used as a mulcher. To convert to bag-
ging, see “TO CON VERT MOW ER” in the
Operation section of this man u al.
Engine connector (male)
Harness
connector
(female)
Battery charger
Charger
connector
(male)
Battery
box