15
• If lubricant is required, use only Texaco
Starplex Pre mi um 1 Grease, Part No.
750369. Do not substitute.
ENGINE
LUBRICATION
Use only high quality detergent oil rated
with API service classifi cation SG–SL.
Select the oil's SAE viscosity grade
according to your expected operating
temperature.
5. Slowly pour oil down the oil fi ll spout,
stopping every few ounces to check
the oil level with the dipstick.
6. Stop adding oil when you reach the
FULL mark on the dipstick. Wait a
minute to allow oil to settle.
7. Continue adding small amounts of oil,
rechecking the dipstick until oil level
settles at FULL. DO NOT overfi ll, or
engine will smoke heavily from the
muffl er on startup.
8. Always be sure to retighten oil dipstick
before starting engine.
9. Re con nect spark plug wire to plug.
AIR FILTER
Your engine will not run properly and may
be damaged by using a dirty air fi lter.
Replace the air fi lter cartridge every 100
hours of op er a tion or every season, which-
ev er occurs fi rst. Service air cleaner more
often under dusty conditions.
TO CLEAN AIR FILTER
1. Loosen screw and tilt cover to re move.
2. Carefully remove cartridge.
3. Clean by gently tapping on a fl at sur-
face. If very dirty, replace car tridge.
CAUTION:
Pe tro leum solvents, such as
ker o sene, are not to be used to clean car-
tridge. They may cause de te ri o ra tion of the
cartridge. Do not oil car tridge. Do not use
pres sur ized air to clean or dry car tridge.
4. Install cartridge, then replace cover
making sure the tabs are aligned with
the slots in the back plate. Fasten
screw securely.
NOTE:
Although multi-viscosity oils
(5W30, 10W30 etc.) improve starting in
cold weather, these multi-viscosity oils will
result in increased oil consumption when
used above 32°F. Check your engine oil
level more frequently to avoid possible
engine damage from running low on oil.
Change the oil after every 25 hours of
operation or at least once a year if the
lawn mower is not used for 25 hours in
one year.
Check the crankcase oil level before
starting the engine and after each fi ve (5)
hours of continuous use. Tighten oil plug
securely each time you check the oil level.
TO CHANGE ENGINE OIL
NOTE
: Before tipping lawn mower to drain
oil, empty fuel tank by running engine until
fuel tank is empty.
1. Disconnect spark plug wire from spark
plug and place wire where it cannot
come in contact with plug.
2. Remove engine oil cap; lay aside on a
clean surface.
3. Tip lawn mower on its side as shown
and drain oil into a suitable container.
Rock lawn mower back and forth to re-
move any oil trapped inside of engine.
TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE
SAE VISCOSITY GRADES
-20
0
30
40
80
100
-30
-20
0
20
30
40
F
C
32
-10
10
60
5W-30
SAE 30
Container
4. Wipe off any spilled oil from lawn
mower or side of engine.
Slots
Lip
Cover
tabs
Back plate
Cartridge
Cover
MUFFLER
Inspect and replace corroded muffl er as it
could create a fi re hazard and/or dam age.
SPARK PLUG
Replace spark plug at the beginning of
each mowing season or after every 100
hours of operation, whichever occurs
fi rst. Spark plug type and gap setting
are shown in the “PROD UCT SPEC I FI C-
A TIONS” section of this manual.
Содержание 917.37707
Страница 21: ...21 ...
