Craftsman 900.74828, Руководство оператора

Страница: 7 / 21

REMOVING BLOW TUBE, VAC TUBE
OR COLLECTION BAG (FIGURE 11)
• To remove the blow tube, vac tube or
shoulder collection bag, depress the
release button on the power head and
pull straight off (
figures 9 & 11 ).
USE AS A BLOWER:
ALWAYS WEAR SAFETY GLASSES.
WEAR A FILTER MASK IF THE
OPERATION IS DUSTY. USE OF
RUBBER GLOVES AND SUBSTANTIAL
FOOTWEAR IS RECOMMENDED
WHEN WORKING OUTDOORS. FOR
HOUSEHOLD USE ONLY.
WARNING: CUT HAZARD. When
turning the tool off for tube installation or
any other reason, wait 10 seconds for
the fan to stop rotating before
disassembly.
• Do not use in vacuum mode without the
vacuum tubes and collection bag in place.
• Always switch off and remove the plug
from the electrical supply when:
• Changing from blower to vacuum.
• The power supply cord has become
damaged or entangled.
• You leave blower/vac unattended.
• Clearing a blockage.
• Checking, adjusting, cleaning or
working on blower/vac.
• Use blower/vac only in daylight or good
artificial light.
ON/OFF SWITCH (FIGURE 12)
Your blower vac is fitted with a variable
speed switch located on the top of the
power head below the handle.
• To turn the tool ON, rotate the knob
clockwise. The further the knob is
rotated, the higher the air speed.
• To turn tool OFF, rotate the knob
counterclockwise to the off position (0).
CORD RETAINER (FIGURE 13)
• A cord retainer is incorporated into the
rear of the power head. It can be used in
two different ways:
• To use the cord retainer as shown in
figure 13A , hook the extension cord
under the retainer. Then plug the cord
from the power head into the extension
cord.
• To use the cord retainer as shown in
figure 13B , loop the extension cord over
the power head cord and plug the two
ends into each other. Then hook the
extension cord under the retainer.
BLOW MODE (FIGURE 14)
WARNING: Ensure product is
switched off and disconnected from the
power supply.
• Fit fan cover grill as shown in figure 1.
• Attach the blow tube assembly to the
power head as shown in figure 2 .
• Connect the cord on the power head to
the power supply ( figure 13 ).
7
10
11
OPERATING INSTRUCTIONS
12
13
13A 13B