Craftsman 536.886180, Руководство оператора

Страница: 17 / 128

4. Insert the safety key ( A , Figure 9) into the safety key slot and
push fully in to the RUN position.
5. Turn the choke knob ( B ) fully clockwise if engine is cold.
NOTE: Do not use the choke to start a warm engine.
6. Push the primer button ( C ) two times.
NOTE: Do not use the primer to start a warm engine.
NOTE: Ensure that electric extension cord is removed from
the power receptacle.
Inserting Safety Key Figure 9
7. Rewind Start: Firmly hold the starter cord handle ( A , Figure
10). Pull the starter cord handle slowly until resistance is felt,
then pull rapidly.
WARNING: Rapid retraction of the starter cord
(kickback) will pull your hand and arm toward the
engine faster than you can let go. Broken bones,
fractures, bruises, or sprains could result. When
starting engine, pull the starter cord slowly until
resistance is felt and then pull rapidly to avoid kickback.
NOTE: If the engine does not start after three attempts, see the
Troubleshooting section in the Engine Manual
.
8. Electric Start: First connect the extension cord to the power
cord receptacle and then into a wall receptacle. If additional
extension cord is required, make sure it is three-wire.
WARNING: If the extension cord is damaged, it must be
replaced by the manufacturer (or its service agent) or a
similarly quali ed person to avoid a hazard.
A
B
C
Starting with Cord Handle Figure 10
9. Electric Start: Depress the starter push button ( A , Figure
11). After you start the engine, rst disconnect the extension
cord from the wall receptacle and then from the power cord
receptacle (
B ).
A
Starting with Electric Start Figure 11
IMPORTANT: To extend the life of the starter, use short starting
cycles ( ve seconds maximum). Wait one minute between
starting cycles.
NOTE: If the engine does not start after three attempts, see the
Troubleshooting section in the Engine Manual.
A
B
17
en
Not
for
Reproduction