SAFETY INSTRUCTIONS
!
3
WARNING
• Study, understand, and follow all instructions
with and on this device before use.
•
Rated capacity is per pair!
Do not exceed
rated capacity.
• Use only on hard, level surfaces capable
of sustaining rated capacity loads.
• One pair per vehicle only!
• Use as a matched pair to support one end
of a vehicle only.
• Support only on areas of the vehicle as
specified by the vehicle manufacturer.
• No alterations shall be made to this
product.
• Failure to heed product markings or
warnings may result in personal injury or
property damage.
BEFORE USING
•
Inspect stands before each use. Do not use
if bent, broken or cracked components are
noted. Ensure that all parts move freely.
•
Verify that the product and the application
are compatible.
OPERATION
•
Before using this product, read this
operator’s manual completely and
familiarize yourself thoroughly with the
product and the hazards associated with
its improper use.
•
Install ratchet bar into frame with ratchet
area of bar aligned with locking pawl
(stopper).
•
Move the ratchet bar to its lowest position
by raising the locking handle, thereby
releasing the stopper, and guiding the
bar downward.
•
Insert roll pin into the bottom hole of the
ratchet bar to prevent inadvertent loss of
the ratchet bar. (refer to Fig. 1)
•
Always check the vehicle owners or
service manual for location of proper lift
and support points.
DAMAGE TO JACK STANDS
If you think jack stand has been subjected to
an abnormal load or shock, have it inspected
for damage at a Sears Service Center before
using it again.
•
To support load
• Adjust height by pulling up on ratchet bar.
• The weight of the locking handle should
secure the ratchet bar in desired position.
To confirm this, simply push down on the
locking handle. Check to ensure ratchet
bar is secure before loading.
• Carefully position stands so that load is
centered on stand’s saddle.
• Slowly lower the vehicle onto the stands.
• Check to ensure vehicle is secure before
working on, around or under. When used
to support vehicle, use wheel chocks to
prevent accidental movement.
•
To lower load
• With suitable jack, raise vehicle clear of
stands.
• Raise the locking handle to release
stopper and allow ratchet bar to glide
down to lowest position.
• Carefully remove stands, then carefully
lower vehicle with jack.
• Ensure that all tools, equipment and
personnel are clear before lowering
load.
MAINTENANCE
To help prevent rust, wipe clean and/or blow dry after each use. Ensure locking handle moves
freely under its own weight. Do not apply oil or lubricant to ANY portion of this product.
Please note that there are no replacement parts applicable to this device.
For after sale support and assistance:
Call 1-888-332-6419 8:00 AM - 4:45 PM CST., Monday - Friday
