5
• Attach the hitch assembly to the frame using five 3/8"
x 2-1/2" hex bolts, ten 3/8" flat washers and five 3/8"
nylock nuts.
Tighten.
See figure 3.
FIGURE 6
FIGURE 5
• Stand the blade in the upright position.
• Assemble the frame to the blade by fitting the clevis
bracket down onto the pivot rod. Secure the clevis
bracket to the pivot rod with the special washer and
a 3/16" x 2" cotter pin. Place the pivot lock pin down
through the holes in the clevis bracket and pivot plate.
Secure the pivot lock pin with a 1/8" hairpin cotter
(large). See figure 6.
FIGURE 4
FIGURE 3
• Assemble two U-bolts around the frame tube and
through the clevis bracket. Assemble four 3/8" nylock
nuts onto the U-bolts. Align the clevis bracket so that it
is straight with the frame and
tighten
the U-bolts and
the center hex bolt. See figure 5.
3/8" x 2-1/2"
HEX BOLT
3/8" FLAT
WASHER
3/8"
NYLOCK
NUT
3/8" FLAT
WASHER
3/8"
NYLOCK
NUT
3/8" FLAT
WASHER
ALIGNING
HOLE
CLEVIS
BRACKET
• Hold the clevis bracket so that the aligning hole is
at the bottom. Insert a 3/8" x 2-1/2" hex bolt through
the center hole in the clevis bracket and then through
the center hole in the rear of the frame. Secure with a
3/8" flat washer and 3/8" nylock nut.
Do not tighten
yet.
See figure 4.
3/8" NYLOCK NUT
U-BOLT
CLEVIS
BRACKET
SPECIAL
WASHER
3/16" x 2"
COTTER PIN
PIVOT ROD
1/8" HAIRPIN
COTTER
PIVOT LOCK PIN
