Craftsman 315.111790, Руководство пользователя

Страница: 12 / 16

12
ALLEN
WRENCH
WARNING:
Always wear safety goggles or
safety glasses with side shields when operating
tools. Failure to do so could result in objects
being thrown into your eyes, resulting in possible
serious injury.
OPERATION
Fig. 10
Fig. 11
MALLET
CHUCK
JAWS
KEYLESS
CHUCK
DRILLING
See Figure 10.
When drilling hard smooth surfaces use a center
punch to mark desired hole location. This will prevent
the drill bit from slipping off center as the hole is
started. However, the low speed feature allows
starting holes without center punching if desired. To
accomplish this, simply operate your drill at a low
speed until the hole is started.
The material to be drilled should be secured in a vise
or with clamps to keep it from turning as the drill bit
rotates.
Hold tool firmly and place the bit at the point to be
drilled. Depress the switch trigger to start tool.
Move the drill bit into the workpiece applying only
enough pressure to keep the bit cutting. Do not force
or apply side pressure to elongate a hole.
WARNING:
Be prepared for binding or
breakthrough. When these situations occur, drill
has a tendency to grab and kick in the opposite
direction and could cause loss of control when
breaking through material. If not prepared, this
loss of control can result in possible serious
injury.
When drilling metals, use a light oil on the drill bit to
keep it from overheating. The oil will prolong the life of
the bit and increase the drilling action.
If the bit jams in workpiece or if the drill stalls, release
switch trigger immediately. Remove the bit from the
workpiece and determine the reason for jamming.
CHUCK REMOVAL
See Figures 11, 12, and 13.
The chuck must be removed in order to use some
accessories. To remove:
■
Lock the switch trigger by placing the direction of
rotation selector in center position.
■
Insert a 5/16 inch or larger allen wrench (hex key
wrench) into the chuck of your drill and tighten the
chuck jaws securely.
■
Tap the allen wrench sharply with a mallet in a
clockwise direction. See
Figure 11. This will
loosen the screw in the chuck for easy removal.