Craftsman 247.88855, Руководство пользователя

Страница: 13 / 64

13
Operating Controls
(See Figure 17.)
Chute Crank
The chute crank is located on the left side of the snow
thrower. To change the direction in which snow is
thrown, turn chute crank as follows:
turn
clockwise to discharge to the left;
turn counterclockwise to discharge to the right.
Chute Distance Control
The distance that snow is thrown can be adjusted by
adjusting the angle of the chute assembly. Push the
chute distance control lever forward to move the
upper chute down and decrease the distance. Pull the
lever back toward the rear to move the upper chute
up and increase the distance.
Left And Right Turn Trigger
The left and right turn triggers are located on the
underside of the handles and are used to assist in
steering your snow thrower. Squeeze the right turn
trigger when turning right, squeeze the left turn trigger
when turning left. Operate your snow thrower in open
areas until you become familiar with these controls.
Shift Lever
The shift lever is located in the center of the handle
panel. It may be moved into one of eight positions:
a. Forward —one of six speeds; position one (1)
is the slowest and position six (6) is the
fastest.
b. Reverse —two reverse (R) speeds; R
2
is
faster.
Use the shift lever to determine ground speed. Do not
shift to different speed while the unit is moving.
Auger Control
The auger control is located on the left handle.
Squeeze the auger control against the handle to
engage the augers; release to disengage the augers.
(Traction drive control must also be released.)
Traction Drive Control
The traction drive control is located on the right
handle. Squeeze the traction drive control to engage
the track drive; release to stop.
This same lever also locks the auger control so
that you can turn the chute crank without interrupting
the snow throwing process. If the auger control is
engaged with the traction drive control engaged, you
can release the auger control (on the left handle) and
the augers will remain engaged. Release the traction
drive control to stop both the augers and the track
drive. (Auger control must also be released).
Weight Transfer Lever
The weight transfer lever is located on the right side of
the snow thrower and is used to select the position of
the housing and the method of track operation. See
Figure 18. Move the lever to the right, then forward or
backward to one of the three positions.
Figure 18
a . Transport —Raises the front end of the
snow thrower for easy transport. Using
proper caution, this position may also be
used on many gravel driveways to clear
snow while leaving gravel undisturbed.
b. Normal Snow —Allows the tracks to be
suspended independently for continuous
ground contact.
c. Packed Snow —Locks the front end of the
snow thrower down to the ground for hard-
packed or icy snow conditions.
Throttle Control
The throttle control is located on the engine. It
regulates the speed of the engine.
Safety Ignition Switch
The ignition key must be inserted into the switch for
the unit to start. Remove the ignition key when the
snow thrower is not in use.
To Stop The Snow Thrower
• To stop the track, release the traction drive lever
of the snow thrower.
• To stop throwing snow, release the auger drive
lever and the drive lever if engaged.
• To stop the engine, push the throttle control
lever to OFF and pull out the ignition key. Do not
turn key.
Transport
Packed
Snow
Normal
Snow