10
ASSEMBLY
B. Slip plastic channel of grass bag over hooks on the frame.
See Figure 7.
2. Follow steps below to attach grass catcher:
A. Lift rear discharge door.
B. Place grass catcher into the slots in the handle brackets as
shown in Figure 8. Let go of discharge door so that it rests
on the grass catcher.
To remove grass catcher, lift rear discharge door on the mower. Lift
grass catcher up and off the slots in the handle brackets. Release rear
discharge door to allow it to close rear opening of mower.
ADJUSTMENTS
Cutting Height
There is a cutting height adjustment lever located above the front and
rear right wheel.
1. Pull the height adjustment lever outward towards wheel (unit will
tend to fall when lever is moved outward). See Figure 9.
2. Move lever to desired position for a change in cutting height. See
Figure 9.
3. Release lever towards deck.
IMPORTANT
: All wheels must be placed in the same position. For
rough or uneven lawns, move each height adjustment lever to a higher
position. This will prevent you from cutting the grass too close to the
ground.
Handle Pitch
For convenience of operation, you may adjust the pitch of the handle
as follows:
1. Remove wing nuts and carriage bolts from handle. See Figure 10.
2. Position the handle in one of the three positions that is most
comfortable. See Figure 10 inset.
3. Secure into position with wing nuts and carriage bolts removed
earlier.
Figure 8
Figure 9
3
2
2
1
3
1
Lower
Lower
Higher
Higher
A
B
B
Figure 7
B
A
Figure 10
2
1
