Craftsman 137.212372, Руководство оператора

Страница: 30 / 54

30 31
7. Looking at the top of the board,
if the laser line is not parallel to
the “pattern line” please follow the
instructions listed below under Top
Line paragraph.
B. Adjusting the Position of the
Laser Line (Fig. X, Y, Z)
Front Line (Fig. X, Y)
If the laser line is angled from left to
right, turn the laser vertical adjustment
knob (1) counterclockwise to align the
line parallel with pattern line. If the laser
line is angled from right to left, turn the
knob clockwise to align the line parallel
with pattern line.
Top Line (Fig. X, Z)
If the laser line is angled from left
to right, turn the laser horizontal
adjustment knob (2) clockwise to align
the line parallel with pattern line. If the
laser line is angled from right to left,
turn the knob counterclockwise to align
the line parallel with pattern line.
After performing the above
adjustments, visually check that both
the front and top laser lines are parallel
with pattern line.
NOTE:
● Laser line is calibrated and set up to
project to the left of the blade.
● If you have any problems or
questions concerning the Laser
Trac
®
, call the following number for
assistance: 1-800-843-1682.
Fig. W
Fig. Y
Fig. Z
Fig. W
TOP VIEW
Laser line
Cutting line
Blade
Laser line
Workpiece
Cutting
line
Laser line
Pattern line
Clockwise Counterclockwise
2
1
Laser line
Pattern line
Clockwise Counterclockwise