Craftsman 137.212372, Руководство оператора

Страница: 20 / 54

20 21
Fig. E
REMOVING AND INSTALLING THE
BLADE
●
To avoid injury from an accidental
start, make sure the switch is in
the OFF position and the plug
is not connected to the power
source outlet.
● Only use a 10 in. diameter blade.
NOTE: The miter saw comes
with the saw blade already
installed. Make sure the blade is
installed correctly and is tight
before operating saw.
●
NEVER cut metals or masonry
products with this tool. This miter
saw is designed for use on wood
and wood-like products only.
Removing the Blade (Fig. F, G, H)
1. Unplug the saw from the outlet.
2. Raise the cutting head to the
upright position, slide the cutting
head assembly completely toward
the rear of the unit and tighten the
sliding carriage lock knob (1).
(Fig. E)
3. Raise the lower blade guard (1) to
the uppermost position. (Fig. F)
4. While holding the lower blade
guard (1), loosen the cover plate
1
WARNING

!
screw (2) with a Phillips screwdriver.
5. Rotate the cover plate (3) to expose
the arbor bolt (4).
6. Place the blade wrench over the
arbor bolt (4).
Fig. F
7. Locate the arbor lock button (5) on
the motor, below the trigger switch
handle. (Fig. G)
8. Press the arbor lock button (5),
holding it in firmly while turning the
blade wrench clockwise. This will
engage the arbor lock allowing the
arbor bolt to be loosened with the
blade wrench. Continue to hold the
arbor lock button (5), while turning
the wrench clockwise to loosen the
arbor bolt (4-Fig. F). (Fig. G)
Fig. G
1
2
4
3
5