|
-26-
Fu
el
Sta
bili
zer
2. Run the engine for a few minutes so the treated fuel
cycles through the fuel system and carburetor.
3. Turn the fuel valve to the “OFF” position.
4. Let the engine run until fuel starvation has stopped
the engine. This usually takes a few minutes.
5. The engine needs to cool completely before
cleaning and storage.
6. Clean the engine according to the Maintenance
section.
7. Change
the
oil.
8. Remove the spark plug and pour about 0.5oz.
(14.9ml) of oil into the cylinder. Crank the engine
slowly to distribute the oil and lubricate the cylinder.
9. Reattach the spark plug.
If you wish to drain the fuel instead of adding fuel
stabilizer, please follow these steps below:
1. Turn fuel valve to the “OFF” position.
2. Remove drain hex screw from the carburetor.
3. Turn fuel valve to the “ON” position and drain the
fuel from the tank, carburetor and hose.
4. Reposition the carburetor drain hex screw once the
fuel is completely drained.
Winter Storage
Protect your pressure washer parts from freezing.
In order to prevent the pump from freezing you will need
to insert RV antifreeze.
You will need approximately 6oz. (177.4ml) of RV
antifreeze, a funnel, and approximately 12inch. (305mm)
of garden hose or equivalent.
1. Apply all storage instructions from previous
sections.
2. Make sure pressure washer hose is free of all water
before storing for winter.
3. Pour the antifreeze into the funnel, then pull on the
engine recoil starter to create suction in the pump
housing.
4. Place the machine on its side with the water inlet
facing upwards, pour 1/4 cup of antifreeze into the
water inlet.
Antifreeze
5. Pull the recoil starter several times
6. Disconnect spark plug wire, and then pull recoil
starter several times to circulate the antifreeze in
the pump system until antifreeze comes out of the
pump outlet.
7. Reconnect spark plug wire.
NOTICE
Always store and transport high pressure washers in a
stable, horizontal position. Support gear case and
cutting blades to prevent excessive flexing, which may
cause damage to these components. Always install
blade cover when transporting or storing unit.
Disposal
Observe all country-specific and local waste disposal
rules and regulations.
CRAFTOP products must not be thrown in the garbage
bin. Take the machine, accessories and packaging to
