|
-19-
Connect the garden hose to pump
1. Align one end threaded fitting on the hose with the
inlet on pump. Assume another end threaded fitting
on the hose has already been connected with the
source of water supply, cold water only.
2. Fully insert/match the threaded fitting with the inlet.
3. Turn the plastic nut on the hose clockwise to tighten
the hose securely to the pump.
Start and stop the engine
WARNING
It is very dangerous to run a high pressure washer that
equipped with broken parts or lacks of any parts. Before
starting the engine, make sure that all the parts
including cutting blades and blades guard are installed
properly.
WARNING
To reduce the risk of serious or even fatal injury:
•
Do not allow children or other unauthorized persons
to attempt to start or otherwise use the machine.
•
Never allow children or unauthorized persons access
to the machine.
•
Never leave the machine unattended while working or
during work breaks
•
After work, store the machine in a safe, secure
location out of the reach of children and other
unauthorized persons
•
Observe safety precautions and instructions.
WARNING
When starting the engine, make sure that your body
does not contact with the muffler. A hot muffler can
cause serious burns.
Start the engine
WARNING
Never start or stop the pressure washer unless the
water supply is turned on.
1. Finish the procedures described in the section of
Pre-operation check list
, make sure your machine is
ready to start the engine.
2. Place the machine on a flat and firm ground in a
clear area.
3. Turn engine switch to “ON” position.
4. Move the fuel valve rightward to the “ON” position.
5. Move the choke lever leftward to “CLOSE”
position.
6. Move the throttle lever leftward to its maximum
setting.
7. Grip the starter rope handle securely, pull it slowly
until resistance is felt, then pull it rapidly until start
the engine(or 5 pulls maximum).
NOTICE
