page 8
9. Light Kit Assembly.
Remove 1 screw from motor plate on
underside of motor and partially loosen the
other 2 screws. Align slotted holes in shade
with loosened screws in motor plate, allowing
molex plugs from motor housing to come
through hole in middle of shade. Twist shade
to lock. Re-insert screw that was previously
removed and securely tighten all 3 screws
with a Phillips screwdriver.
Remove 1 screw from underside of shade and
partially loosen the other 2 screws. Connect
WHITE
wire from motor housing to
WHITE
wire from LED light kit . Connect
BLACK
wire
from motor housing to
BLACK
wire from LED
light kit. Be sure molex connections snap
together securely. [
Note:
If you will NOT be
using the light kit, do NOT connect the plugs.]
Carefully arrange wiring within the back of
LED light kit. Align slotted holes in LED light
kit with loosened screws in shade. Twist LED
light kit to lock. Re-insert screw that was
previously removed and securely tighten all
3 screws.
Locate slots on LED light kit and align with
small posts on edge of light kit frame.
Turn
light kit frame
to the RIGHT (clockwise)
until
it locks into place.
CAUTION
: D
o
not
connect the LED light kit if
you do NOT wish to use the light.
shade
motor plate
motor housing
molex
connections
screws
screw
shade
LED light kit
light kit frame
molex
connections
slots
