page 9
dimmer
switch
wall control
wire
wire
wire
12V battery
IN ORDER TO USE THE HANDHELD REMOTE
CONTROL, CONTINUE WITH SECTION 10 for remote
control assembly instructions. If you have already
installed the wall control but do
not
wish to use
the handheld remote control, please proceed to
Section 11.
Gently pull on remote control cover to separate
top and bottom parts. [
Refer to
diagram 1
.
]
In order to use wall control as a handheld
remote control, cut each wire on wall control
(that was not previously used)--use wire cutters
to cut off each wire as close to the wall control
as possible. [
Refer to
diagram 2
.
]
Install one battery (included) in wall control.
[
Refer to
diagram 2
.
]
The dimmer switch (labeled
DIM
and
ON
) has
been pre-set to the "ON" position (
DIM
). If you
do not wish to have dimming capability, please
move the switch to the "OFF" position (
ON
).
[
Refer to
diagram 2
.
]
Align holes in wall control with posts located on
inside
of TOP part of remote control cover and
press together firmly. Place wall control into
BOTTOM part of remote control cover, aligning
posts in top of remote control cover with post
holes in the bottom. [
Refer to
diagram 3
.
]
(
NOTE
: Make sure to align narrower ends of
remote control cover before closing.) Squeeze
top and bottom of remote control cover
together until you hear a click at each end,
indicating that the remote control cover has
closed completely.
IMPORTANT
: Store the remote control away
from excess heat or humidity. To prevent
damage to remote control, remove the battery if
remote control will not be used for long periods.
(top)
(bottom)
remote
control
cover
wall
control
remote control
cover,
BOTTOM
post
hole
diagram 1
diagram 2
diagram 3
post
hole
remote control
cover,
TOP
I
II
IV
VI
III
V
I
II
IV
VI
III
V
SET button
10. Handheld Remote Control Assembly.
