5. Fan Assembly.
page 4
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Lower hanging
ball and remove stop pin and then slide hanging ball
off of the downrod. [
Refer to
diagram 1
.
]
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor housing
yoke. [
Refer to
diagram 2
.
]
Tip
: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will keep
the wires together when threading them through
the downrod. [
Refer to
diagram 2
.
]
Determine the length of threaded downrod you wish
to use. Thread safety cable and electrical wires
through threaded end of downrod and pull extra
wire slack from the upper end of the downrod. [
Refer
to
diagram 2
.
]
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes in
yoke--
make sure wires do not get twisted
. Re-insert pin
and clip that were previously removed. Tighten yoke
set screws and nuts securely. [
Refer to
diagram 2
.
]
Locate canopy cover in hardware pack. Slide yoke
cover, canopy cover and canopy over downrod.
[
Refer to
diagram 3
.
] (
Note
: Canopy cover must be
turned with shiny side
toward
the motor housing.)
Thread safety cable and wires through hanging ball
and then slide hanging ball over downrod--the top
of the downrod should be noted as having a set
screw hole; use this hole when setting the set screw.
Insert stop pin into top of downrod and raise
hanging ball. Be sure stop pin aligns with slots on the
inside of the hanging ball. Tighten set screw securely.
[
Refer to
diagram 4
.
]
WARNING
: Failure to tighten set screw (on hanging
ball) completely could result in the fan becoming
loose and possibly falling.
["Fan Assembly" continued on next page.]
NOTE
: The important safety precautions and
instructions appearing in the manual are not meant to
cover all possible conditions and situations that may
occur. It must be understood that common sense and
caution are necessary factors in the installation and
operation of this fan.
set screw
hanging ball
stop pin
set screw hole
stop pin
diagram 2
diagram 1
diagram 4
diagram 3
clip
pin
canopy
canopy
motor
housing
yoke cover
canopy cover
downrod
downrod
electrical wiring
safety cable
yoke set screw
and nut
hanging ball
motor
housing
