page 6
7. Canopy Assembly.
Temporarily raise canopy to hanging bracket
to determine which 2 screws align with
slotted
holes in canopy, and then lower canopy and
partially loosen
these 2 screws.
Remove
the
other
2 screws/lock washers and set aside.
Now, lift canopy to hanging bracket again,
aligning slotted holes in the canopy with
loosened screws in hanging bracket. Twist
canopy to lock. Re-insert the other 2
screws/lock washers and secure all screws with
a Phillips screwdriver.
8. Blade Assembly.
WARNING
: To reduce the risk of serious bodily
injury,
DO NOT use power tools to assemble the
blades. If screws are overtightened, blades may
crack and break.
Locate 15 blade attachment screws and
15 decorative nuts in one of the hardware
packs. Place blade arm on
TOPSIDE
of blade,
aligning holes in blade arm with holes in blade
as shown. [
Be sure to note label on blade
indicating
THIS SIDE UP
and turn blade so that
label faces up
]. Insert 3 decoratvie nuts from
UNDERSIDE
of blade (
i.e., the side that will face
the floor
), making sure to
completely insert
each decorative nut so that the blade arm can
be attached correctly. Insert 3 blade attachment
screws from
TOPSIDE
of blade with fingers first
and then tighten screws securely with a Phillips
screwdriver. Repeat procedure for remaining
blades.
Remove blade arm screws and lock washers
from fan motor and set aside. [
WARNING
: Do
NOT remove the 4 screws located on the outer
rim of the underside of the motor housing--
doing so or any attempt at doing so will void
the warranty.] Align blade arm holes with
motor screw holes and attach blade arm with
lock washers and blade arm screws. Before
securing screws permanently, repeat this
procedure with remaining blade arms. Secure
all screws.
NOTE
: Tighten blade arm screws twice a year.
motor
housing
blade
decorative
nuts
blade arm
blade attachment
screws
blade arm screws
canopy
hanging bracket
slotted
hole
