page 9
10. Handheld Remote Control Assembly. (cont.)
Align holes in wall control with posts located on
inside
of TOP part of remote control cover and
press together firmly. Place wall control into
BOTTOM part of remote control cover, aligning
posts in top of remote control cover with post
holes in the bottom. [
Refer to
diagram 3
.
]
(
NOTE
: Make sure to align narrower ends of
remote control cover before closing.) Squeeze
top and bottom of remote control cover together
until you hear a click at each end, indicating that
the remote control cover has closed completely.
IMPORTANT
: Store the handheld remote control
away from excess heat or humidity. To prevent
damage to handheld remote control, remove the
battery if remote control will not be used for long
periods.
wall
control
remote control
cover,
BOTTOM
post
hole
diagram 3
post hole
remote control
cover,
TOP
I
II
IV
VI
III
V
11. Automated Learning Process./Activating Code.
wall control
faceplate
(almond
or white)
I
II
IV
VI
III
V
OFF
ON
SET button
faceplate
(black)
handheld
remote control
I
II
IV
VI
III
V
OFF
ON
SET button
CAUTION
:
The wall and/or handheld remote control
can be programmed to multiple receivers or fans. If
this is not desired, turn wall switch off to any other
programmable receiver or fan.
Restore electrical power and then, if using wall
control, set slider switch on wall control to the
ON position. Within 60 seconds of turning on the
wall control, press and hold the fan
SET
button
on the wall control for 5 seconds or until light
blinks twice.
Turn power off again for at least 5 seconds
and
then turn power back on. Within 60 seconds of
restoring the power, press and hold the fan
SET
button on the handheld remote control for
5 seconds or until light blinks twice.
Test the light and fan functions to confirm the
learning process is complete--
see Section 13 on
the following page.
Select a faceplate (
almond or white
) and press
firmly onto front of wall control that was
previously installed to the outlet box on the wall.
[
Refer to
diagram 1
.
]
Attach
black faceplate
to front of handheld
remote control; press down firmly. [
Refer to
diagram 2
.
]
diagram 1
diagram 2
