page 6
7. Canopy Assembly.
Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw. Lift
canopy to hanging bracket. Place rounded part of
slotted hole in canopy over loosened screw in
hanging bracket and push up. Twist canopy to lock.
Re-insert screw that was removed and then tighten
both screws securely.
8. Blade Assembly.
WARNING
: To reduce the risk of serious bodily
injury,
DO NOT use power tools to assemble the
blades. If overtightened, blades may crack and
break.
Time Saver
: Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers
in hardware pack. Hold blade arm up to blade
and align holes. Insert 3 blade attachment
screws (along with washers) with fingers first
and then tighten screws securely with a Phillips
screwdriver. Repeat for the remaining blades.
Remove blade arm screws/lock washers from
underside of motor. If plastic motor locks are
installed with blade arm screws, discard plastic
motor locks (
save blade arm screws and lock
washers to secure blade arms
).
NOTE
: Additional
blade arm screws are located in one of the
hardware packs.
Align blade arm holes with motor screw holes
and attach blade arm with blade arm
screws/lock washers. Before securing screws
permanently, repeat with remaining blade arms.
Securely tighten all screws.
NOTE
: Tighten blade arm screws twice a year.
hanging bracket
screw
canopy
screw
blade arm
blade
blade attachment
screws and washers
blade arm
screws/lock washers
motor housing
plastic
motor
lock
