page 9
10. Automated Learning Process./Activating Code.
CAUTION
: The remote control transmitter can be
programmed to multiple receivers or fans. If this is
not desired, turn wall switch off to any other
programmable receiver or fan.
Remove battery cover on back side of remote
control transmitter. Install one 12-volt battery
(included).
WARNING: Battery is to be inserted with the
correct polarity.
Since this fan comes with an LED light kit, the
dimmer switch (labeled ON and D) has been
pre-set to the "ON" position (ON). If you do not
wish to have dimming capability, please move
the switch to the "OFF" position (D).
Restore electrical power.
Turn power off again
for at least 5 seconds
and then turn power
back on. Within 60 seconds of restoring the
power, press and hold the fan
SET
button for
5 seconds or until light blinks twice. Then
replace the battery cover.
NOTE
: Remove battery with low or no charge
and dispose of properly.
IMPORTANT
: Store the handheld remote
control away from excess heat or humidity. To
prevent damage to handheld remote control,
remove the battery if handheld remote control
will not be used for long periods.
CAUTION
: “DO NOT DISPOSE OF BATTERIES IN
FIRE, BATTERIES MAY EXPLODE OR LEAK.” -
When disposing of household alkaline
batteries, it is best to check with your local and
state recycling or household hazardous waste
coordinators concerning the specifics of the
program in your area. You may also locate a
recycling center by calling 1-800-8-BATTERY
or 1-877-2-RECYCLE or visit
www.epa.gov/epawaste/index.htm or
www.earth911.org for more information.
WARNING
:
Choking Hazard
- Small parts. Keep
battery away from children.
WARNING
: Battery is NOT rechargeable. A
non-rechargeable battery is not to be
recharged.
battery cover
SET
dimmer
switch
REMOTE CONTROL
(
back side
)
REMOTE CONTROL
(
front
)
I
I I
IV
VI
I I I
V
battery
