page 8
9. Light Kit Assembly.
Remove 1 screw from motor plate on underside
of motor housing and partially loosen the other
2 screws. Align slotted holes in fitter plate with
loosened screws in motor plate, allowing molex
connections from motor housing to come
through hole in middle of fitter plate--remove
and discard plastic that holds these 2 wires
together. Twist fitter plate to lock. Re-insert
screw that was just removed and securely
tighten all 3 screws with Phillips screwdriver.
Remove 1 screw from underside of fitter plate
and partially loosen the other 2 screws.
Connect WHITE wire from motor housing to
WHITE wire from LED light kit. Connect BLUE (or
BLACK) wire from motor housing to BLACK wire
from LED light kit. [NOTE: It may be necessary to
push back sleeve on wires to be certain of wire
colors.] Be sure molex connections snap together
securely.
Carefully arrange wiring within fitter plate. Align
slotted holes in LED light kit with loosened
screws in fitter plate. Twist LED light kit to lock.
Re-insert screw that was previously removed and
tighten all 3 screws securely.
Align grooves in fitter plate with nodules on
inside of shade and push up gently on shade.
Twist shade to the RIGHT (clockwise) until shade
locks into place.
Pull down GENTLY on shade to make sure that
shade is secure.
fitter plate
molex connections
motor plate
motor
housing
motor
housing
shade
fitter plate
fitter plate
LED light kit
molex
connections
motor
housing
groove
nodule
