page 8
9. Light Kit Assembly, 1-light Options.
shade
bulb
light kit fitter
switch
housing
fan pull chain
reverse
switch
black wire
blue
(or black)
wire
white
wire
molex
connections
white wire
finial
finial plate
threaded washer
Remove 3 screws from switch housing cap (at
top of light kit fitter).
Locate BLUE (or BLACK) and WHITE wires in
switch housing labeled FOR LIGHT KIT
CONNECTION. Remove and discard plastic that
holds these 2 wires together.
Connect WHITE wire from switch housing to
WHITE wire from light kit fitter. Connect BLUE
(or BLACK) wire from switch housing to BLACK
wire from light kit fitter. Be sure molex
connections snap together completely.
Align holes in switch housing cap with holes in
switch housing. (NOTE: The gap on the edge of
the switch housing cap must align with the
reverse switch on the switch housing for the
proper fit.) Re-insert screws that were
previously removed. Securely tighten all
3 screws with a Phillips screwdriver.
Install bulbs included with light kit.
IMPORTANT: When you need to replace bulbs,
please allow bulbs and shade to cool down
before touching them.
Remove finial, finial plate and threaded washer
from threaded rod on light kit fitter. Raise shade
in order to guide pull chains through
appropriate holes at bottom of shade. Align
threaded rod on light kit fitter with hole in
middle of shade and push up gently, allowing
threaded rod to come through hole. (Be sure
pull chain for fan operation does not rub against
bulb during operation.) Secure shade with
threaded washer. Do NOT overtighten threaded
washer as shade may crack or break. Align hole
in center of finial plate with threaded rod,
allowing pull chains to come through
appropriate holes in finial plate, and push up.
Thread center pull chain through hole in finial
and re-attach finial. Do NOT overtighten finial as
shade may crack or break.
Please proceed to Section 11 on page 10 to
complete installation.
switch housing
motor housing
switch housing cap
light kit fitter
molex
connections
*For Models P101 and P211, follow instructions on this page.
*For Models P104 and P114, proceed to instructions on page 19.
