5. Fan Assembly.
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Lower
hanging ball and remove stop pin and then slide
hanging ball off of the downrod. [
Refer to
diagram
1
.
]
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor housing
yoke. [
Refer to
diagram 2
.
]
Tip
: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod. [
Refer to
diagram 2
.
]
Determine the length of downrod you wish to use.
Thread electrical wires through threaded end of
downrod and pull extra wire slack from the upper
end of the downrod. [
Refer to
diagram 2
.
]
Thread downrod into the motor housing yoke
until holes for pin and clip in downrod align with
holes in yoke--
make sure wires do not get twisted
.
Re-insert pin and clip that were previously
removed. Tighten yoke set screws and nuts
securely. [
Refer to
diagram 2
.
]
Slide yoke cover and canopy over downrod. [
Refer
to
diagram 3
.
]
["Fan Assembly" continued on next page.]
NOTE
: The important safety precautions and
instructions appearing in the manual are not meant
to cover all possible conditions and situations that
may occur. It must be understood that common
sense and caution are necessary factors in the
installation and operation of this fan.
set screw
hanging ball
stop pin
diagram 2
diagram 1
page 5
downrod
electrical wiring
yoke set screw
and nut
pin
motor
housing
clip
diagram 3
motor
housing
canopy
downrod
yoke cover
