13. Testing Your Fan.
It is recommended that you test fan before finalizing installation.
Restore power from circuit box and light switch (if applicable). Test
wall control (optional installation) by locating ON/OFF slider switch
on wall control, then set to the ON position. Test the light ON/OFF
and dimmer function with L button and then test fan speeds. Next,
locate handheld remote control. Test the light ON/OFF function by
pressing the L button; test the dimmer function by pressing the L
button and holding it down for up to 5 seconds. Test fan speeds
with the different fan speed buttons. If the wall and/or handheld
remote control operates all of the functions of the fan and light,
battery/batteries has/have been installed correctly. If the wall
and/or handheld remote control do (does) not operate all of the
fan/light functions, refer to "Troubleshooting" section to solve any
issues before contacting Customer Service.
Turn fan completely off before moving the reverse switch (located
on top of motor housing). Set reverse switch to recirculate air
depending on the season:
- LEFT position in summer (diagram 1)
- RIGHT position in winter (diagram 2)
A ceiling fan will allow you to raise your thermostat setting in
summer and lower your thermostat setting in winter without
feeling a difference in your comfort.
Important: Reverse switch must be set either completely LEFT or
completely RIGHT for fan to function. If the reverse switch is set in
the middle position (diagram 3), fan will not operate.
NOTE: If the wall control/handheld remote control interfere(s) with
other appliances, turn off power first and then go back to the
instructions in Section 11 above.
page 11
12. Remote Control Operation.
ON/OFF slider switch - turns wall control ON or OFF
(switch not functional on
handheld remote)
HIGH button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
OFF button - turns fan OFF
L button - turns light kit ON/OFF when pressed
once; dims light kit when pressed and
held down.
CAUTION: The wall and/or handheld remote control can be programmed to multiple receivers or fans. If
this is not desired, turn wall switch off to any other programmable receiver or fan.
Restore electrical power and then, if using wall control, set slider switch on wall control to the ON
position. Within 60 seconds of turning on the wall control, press and hold the fan OFF button on
the wall control for 5 seconds (or until light blinks twice or fan blades begin to turn).
Turn power off again for at least 5 seconds and then turn power back on. Within 60 seconds of
restoring the power, press and hold the fan OFF button on the handheld remote control for 5
seconds (or until light blinks twice or fan blades begin to turn).
Test the light and fan functions to confirm the learning process is complete--see Section 13 below.
11. Automated Learning Process./Activating Code.
wall control
handheld
remote control
motor
housing
reverse
switch
