page 9
9. Light Kit Assembly.
Remove 1 screw from motor plate on
underside of motor housing and partially
loosen the other 2 screws.
Align slotted holes in fitter plate with
loosened screws in motor plate, allowing
molex connectors to come through center
hole in fitter plate. Twist fitter plate to lock.
Re-insert screw that was previously removed
and securely tighten all 3 screws with a
Phillips screwdriver. [
Refer to
diagram 1
.
]
Remove 1 screw from underside of fitter
plate and partially loosen the other 2 screws.
Connect
WHITE
wire from motor housing to
WHITE
wire from the light kit and
BLUE
(or
BLACK
)
wire from motor housing to
BLACK
wire from LED light kit. Make sure molex
connections snap together completely.
Carefully arrange wiring within the back
of LED light kit. Align slotted holes in LED
light kit with loosened screws in fitter
plate. Twist light kit to lock. Re-insert screw
previously removed and securely tighten
all 3 screws with a Phillips screwdriver.
[
Refer to
diagram 2
.
]
Align grooves on shade with nodules on
inside edge of light kit and push up gently
on shade. Twist shade to the RIGHT
(clockwise) until glass shade locks into place.
Pull down VERY GENTLY on shade to make sure
that shade is secure.
[
Refer to
diagram 3
.
]
diagram 1
diagram 3
fitter plate
fitter plate
light kit
grooves
nodule
shade
screw
motor plate
motor
housing
diagram 2
molex connections
screw
molex
connections
LED light kit
