page 8
7. Canopy Assembly.
8. Blade Assembly.
Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen the
other screw. Lift canopy to hanging bracket.
Place rounded part of slotted hole in canopy
over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw
that was removed and then tighten both
screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it
stops.
*Remember that antenna for remote control
receiver must rest
outside
of hanging bracket.
WARNING
: To reduce the risk of serious
bodily injury,
DO NOT use power tools to
assemble the blades. If screws are
overtightened, blades may crack and break.
Locate 9 blade attachment screw/washers
in hardware pack. Slide blade through one
of the narrow, rectangular openings on
motor housing, aligning holes in blade with
holes in blade arm (
located on the
underside of the motor housing
)--
refer to
drawing at right
. Insert 3 blade attachment
screws/washers with fingers first and then
tighten screws securely with a Phillips
screwdriver. Repeat procedure for each
remaining blade.
Note
: Tighten blade attachment screws
twice a year.
screw
hanging bracket
canopy
canopy cover
receiver
antenna
screw
motor housing
blade attachment
screws/washers
blade
